Pepperl+Fuchs HD2-DM-A Manual page 89

Advanced diagnostics
Hide thumbs Also See for HD2-DM-A:
Table of Contents

Advertisement

Advanced Diagnostics
FDS/OPC Integration
5.12.3
Trigger Description
To make sure that the triggered frame is valid, every trigger event occurs at the end of the
frame.
Trigger Events for FOUNDATION Fieldbus
Name
Pass Token to address
ProbeNode to address
Token usage from address
Missing Token usage from address
(next valid bus address is triggered)
Probe Response from address
Missing Probe Node Response from address Trigger if a probe node is sent to the specified
Claim LAS from address
Transfer LAS to address
Maintenance Required by address
(available since diagnostic manager version
1.3)
Out of Specification by address
(available since diagnostic manager version
1.3)
Trigger Events for PROFIBUS PA
Name
Request from address
Response from address
Missing Response from address
(next valid bus address is triggered)
Pass Token to address
Missing Pass Token response from address
Result
Trigger if the specified addresses send frames
after receiving a pass token.
Trigger if a probe node is sent to the specified
address, but no probe node response is
detected as the next frame.
Trigger if the specified addresses send frames
after receiving a pass token.
Trigger if a pass token is sent to the specified
address, but is not used from this dress after-
wards.
Trigger if a probe node frame to the specified
address is detected.
address, but no probe node response is
detected as the next frame.
Trigger if a Claim LAS frame is detected from
the specified address.
Trigger if a Transfer LAS frame to a specified
address is detected.
Triggers when one of the parameters noise, jit-
ter or signal level gets into state maintenance
required.
Note: Amplitude, recording length, and pre-
trigger time are set automatically independent
from the settings here.
Triggers when one of the parameters noise, jit-
ter or signal level gets into state out of specifi-
cation.
Note: Amplitude, recording length, and pre-
trigger time are set automatically independent
from the settings here.
Result
Trigger if any request frame is detected from
the specified address.
Trigger if any response frame is detected from
the specified address.
Trigger if the slave at the specified address
does not respond on a request.
Trigger if a pass token frame to the specified
address is detected.
Trigger if a master at the specified address
does not react on a Pass Token frame.
89

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kt-mb-dmaKt-mb-gt2ad.ffKt-mb-gt2ad.ff.io

Table of Contents