Pepperl+Fuchs HD2-DM-A Manual page 90

Advanced Diagnostics
FDS/OPC Integration
Name
Maintenance required by address
(available since diagnostic manager version
1.3)
Out of Specification by address
(available since diagnostic manager version
1.3)
Note
The CRC values of the advanced diagnostic module and the host system can differ, depending
on the fault tolerances.
Other Trigger Events
Name
CRC error
Framing error
Signal level
5.12.4 Toolbars and Shortcuts
Note
If you close the oscilloscope dialog, all unsaved recordings are lost.
Recording Toolbar
Button
90
Result
Triggers when one of the parameters noise, jit-
ter or signal level gets into state maintenance
required.
Note: Amplitude, recording length, and pre-
trigger time are set automatically independent
from the settings here.
Triggers when one of the parameters noise, jit-
ter or signal level gets into state out of specifi-
cation.
Note: Amplitude, recording length, and pre-
trigger time are set automatically independent
from the settings here.
Result
Trigger if a fieldbus frame with a CRC error is
detected.
Trigger if a frame is invalid (e. g., SOF
detected but EOF missing).
Trigger if a voltage higher than the specified
value is detected. Triggers exist for signals,
noise, etc.
Name
Cancel Recording
Open
Save
Export as Image
Page Setup
Print
Result
Cancel the current oscillo-
scope record.
Open a saved oscilloscope
record.
Save oscilloscope record as
XML-file.
Save the current view of the
oscilloscope graph as image.
File types: png, jpeg, gif, bmp
The page setup object con-
tains all page setup attributes:
Paper size, left margin, bottom
margin and so on.
Print the current view of the
oscilloscope graph.