Table of Contents
Advertisement
Advanced Diagnostics
Appendix
Parameter
SYSTEM
SYSTEM_DY-
NAMIC
All segment parameters exist 4x, once for each ADM segment. X = 1 ... 4
EXPERT_SYS
TEM_(X)
150
Char.
Description
Record, S, W,
HISTORY_PERIOD:
OOS
History period of the ADM. Controls the number of times the
ADM writes a history entry to its non-volatile memory. History
can be read via DTM function "History export".
FLASH_LEDS:
Causes the ADM device to have all LEDs flashing for identifi-
cation purpose.
Record
ADM_SERIAL_NUMBER:
Serial number of the attached ADM.
ADM_SofTWARE_REVISION:
Software version of attached ADM.
ADM_PROTOCOL_REVISION:
Internal usage
ADM_EXPERT_REVISION:
Internal usage
BOARD_TYPE:
Motherboard type the ADM is mounted on.
U_PWR_HI_HI_OOS:
Bulk power supply High-Out-of-Specification limit.
U_PWR_LO_LO_OOS:
Bulk power supply Low-Out-of-Specification limit.
U_PWR_PRI:
Actual measured value of primary bulk power supply voltage.
U_PWR_SEC:
Actual measured value of secondary bulk power supply volt-
age (not available on some motherboards).
SYSTEM_ALARMS:
List of active system alarms:
•
Primary power supply high Out of Specification
•
Primary power supply low Out of Specification
•
Secondary power supply high Out of Specification
•
Secondary power supply low Out of Specification
Record, W
RESET_INACTIVE:
Clears inactive messages
OVERALL_STATUS:
Overall segment diagnostic quality. Possible values: are
•
No Error (commissioned)
•
Maintenance Required (commissioned)
•
Out of Specification (commissioned)
•
Excellent (non-commissioned)
•
Good (non-commissioned)
•
Out of Specification (non-commissioned)
•
Fail (ADM hardware error)
•
Configuration Error (see expert messages for information)
•
No corresponding ADM connected
•
Segment is disabled
5x expert diagnostic messages consisting of "Active" flag and
the actual message. N = 1 ... 5
ACTIVE_(N):
Following expert message is active (the error is present) or
inactive (the error is gone).
Advertisement
Table of Contents
