Pepperl+Fuchs HD2-DM-A Manual page 155

Advanced Diagnostics
Appendix
Parameter
Configuration data of nodes. The record is used 6 times (Z=1..6),18 nodes are configurable
(Y=1-18)
SEG-
MENT_(X)_D
EV_STAT-
IC_-
DATA_(Z)
Z=
1_3
4_6
7_9
10_12
13_15
16_18
154
Char. Description
H1_SEGMENT_NONCOM_STATUS:
List of segment errors in non-commissioned mode:
• Power supply A error
• Power supply B error
• Segment voltage high Out of Specification
• Segment voltage high Good
• Segment voltage low Good
• Segment voltage low Out of Specification
• Segment current high Good
• Unbalance high Out of Specification
• Unbalance high Good
• Unbalance low Good
• Unbalance low Out of Specification
• Signal level high Out of Specification
• Signal level high Good
• Signal level low Good
• Signal level low Out of Specification
• Noise high Out of Specification
• Noise high Good
• Jitter high Out of Specification
• Jitter high Good
• Trunk surge protector alarm
H1_ERROR_RATE_ACT:
Error rate in actual history period – number of errors per
frames received.
H1_ERROR_RATE_LAST:
Error rate in previous history period – number of errors per
frames received
Record, W, S,
DEVICE_(Y)_ADDRESS:
OOS Field device address:
• 0: Entry is not used (default)
• 1 ... 254: Entry is used
DEVICE_(Y)_TAG:
Field device tag
DEVICE_(Y)_SIGNAL_LEVEL_HI_HI_OOS:
Enable or disable segment maximum signal level High-Out-of-
Specification limit
DEVICE_(Y)_SIGNAL_LEVEL_HI_MR:
Segment maximum signal level High-Maintenance-Required
limit
• 0 mV: Disabled
• 100 mV ... 2200 mV: Enabled