Pepperl+Fuchs HD2-DM-A Manual page 87

Advanced Diagnostics
FDS/OPC Integration
5.12 Fieldbus Oscilloscope
5.12.1 Oscilloscope Recording Settings
The built-in oscilloscope enables in-depth analysis of the fieldbus signal level during a defined
time period, for example, if a specific telegram type was detected or if communication issues
occurred.
Opening the Fieldbus Oscilloscope
In order to open the fieldbus oscilloscope, proceed as follows:
1.
Right-click the Advanced Diagnostic Module in the project section.
2.
Choose Additional Functions > Fieldbus Oscilloscope.
The fieldbus oscilloscope window appears.
Figure 5.56
1 Record toolbar
Start/cancel signal recording
2
(depending in the system, a reaction delay of up to 5 s is possible)
3 Recording length
default value = 32.768 ms/sample rate = 2 MS/s
4 Recent recordings tab
5 Trigger events
6 Trigger options
3
4
5
6
Record settings overview
1
2
87