Pepperl+Fuchs HD2-DM-A Manual page 21

Advanced Diagnostics
Product Description
Mounting of HD2-DM* Modules on the Motherboard
To install a new module on the motherboard, proceed as follows:
1.
Carefully center the polarization holes and mate the two connectors, then gently press down
the module.
2.
Push down the red Quick Lok bars on each side of the module to fix it to the panel.
Figure 3.3
The new module has been installed.
Dismounting Modules from the Motherboard
To dismount a module from the motherboard, proceed as follows:
Pull up the red Quick Lok bars on each side of the module and carefully lift off the entire mod-
ule.
The module has been removed from the motherboard.
3.2 KT-MB-DMA - Advanced Diagnostic Module, Kit for Stand-Alone
Operation
General Overview
The stand-alone diagnostic kit consists of an HD2-DM-A plug-in module (see chapter 3.1) and
a motherboard to connect the HD2-DM-A to up to 4 segments. It is specially designed to lead
the advanced diagnostic features in areas where continuous monitoring of the physical layer is
crucial and no FieldConnex
Mounting HD2-DM*
®
Power Hubs are installed.
21