Pepperl+Fuchs HD2-DM-A Manual page 83

Advanced Diagnostics
FDS/OPC Integration
Note
For more information on the parameters, see chapter 5.8.
5.10.1 Field Device Handling
The advanced diagnostic module (ADM) classifies the field devices as configured field devices
and unconfigured field devices. See also see chapter 2.2.4. The advanced parameterization
allows for either of the following configured device list actions:
• Add unconfigured field devices
• Add new configured field devices
• Remove configured field devices that are no longer required
Adding an Unconfigured Field Device
In order to add an unconfigured field device, proceed as follows:
1.
Right-click the Advanced Diagnostic Module in the project section and choose Additional
Functions > Advanced Parameterization.
The advanced parameterization window appears.
2.
Select the segment in the Device Navigation section.
The segment window appears.
3.
Select the Field Devices tab.
4.
Mark the field devices you intend to add in the Unconfigured Field Devices section.
5.
Choose Add selected Field Device.
Figure 5.51
The new field device is located in the configured field devices list.
6.
Choose Apply.
Adding a New Field Device
In order to add a new field device, proceed as follows:
1.
Right-click the Advanced Diagnostic Module in the project section and choose Additional
Functions > Advanced Parameterization.
The advanced parameterization window appears.
2.
Select the segment in the Device Navigation section.
The segment window appears.
Unconfigured field devices section
83