Pepperl+Fuchs HD2-DM-A Manual page 69

Advanced Diagnostics
FDS/OPC Integration
5.
If necessary, you can modify these values before storing them on the advanced diagnostic
module. Note that the out-of-specification alarm for the primary and secondary power supply
will be enabled automatically by default.
6.
Choose Next.
System warning and alarm limit values are now stored on the diagnostic device.
Figure 5.32
7.
Choose Restart to confirm changed settings and to return to the commissioning wizard start
page.
5.6.5 Segment Commissioning
Performing Segment Commissioning with the Commissioning Wizard
To perform segment commissioning, proceed as follows:
1.
Open the commissioning wizard. See chapter 5.6.3
2.
Perform system commissioning. See chapter 5.6.4
3.
In the segment commissioning section of the commissioning wizard start page choose the
Segment you want to commission.
The topology settings window appears.
4.
Choose Next.
The field device tags window appears.
5.
Choose Next.
Current segment measurements and field device signal level tabs are shown.
6.
Choose Next.
The system takes a snapshot and generates a printable report that is stored in the snapshot
explorer. See chapter 5.9. In case the expert system detects any issues while recording the
snapshot, ensure to ignore these if you intend to proceed with the commissioning. Not
ignoring them will cancel the commissioning procedure and generate a report of the failed
commissioning. Before the report is generated, you can add a comment to the report and
select an option to include characteristic oscilloscope recording fragments for each field
device to the report.
7.
Choose Next.
The physical layer measurement report appears.
8.
Choose Next.
Current system data with automatically calculated limits are shown.
System commissioning succeeded
69