Pepperl+Fuchs HD2-DM-A Manual page 105

Advanced Diagnostics
FOUNDATION Fieldbus Integration
License Activation
Before entering the license key, ensure that the diagnostic manager is closed.
1.
Choose Start > Programs > Pepperl+Fuchs > Activation Tool to start the Pepperl+Fuchs
license activation tool.
The license activation tool window appears.
Figure 6.2
2.
Enter your license key.
3.
Choose Activate.
4.
After the activation has been confirmed, choose Finish.
6.7 Project Setup
The DGW-FF DTM for the HD2-GT-2AD.FF.IO can be used in 2 different project structures:
Use the FF-H1 Communication DTM
The HD2-GT-2AD.FF.IO DTM can be connected to any FF-H1 communication DTM and FF-H1
communication channel of your PCS. The communication to the device takes place using FF-
H1. Refer to the documentation of your field device tool (FDT) frame on how to connect the
HD2-GT-2AD.FF.IO DTM to an FF-H1 communication channel.
Use the HD2-GT-2AD.FF.IO Communication DTM
During commissioning of a plant, the host may not be available yet, but the physical layer must
already be commissioned. For such use cases, a PC, e.g., a laptop, can be connected to the
diagnostic gateway via Ethernet. Alternatively, Ethernet communication with a much higher
communication performance can be used. The DGW-FF DTM can be connected to a special
communication DTM included in the same installation package. This communication DTM
transfers the FOUNDATION Fieldbus H1 communication over Ethernet and allows the DGW-
FF DTM to provide the same functionality as via FOUNDATION Fieldbus H1. Typically, a
stand-alone FDT frame, e.g., PACTware
License activation tool
TM
is used for this setup.
105