Pepperl+Fuchs HD2-DM-A Manual page 60

Advanced Diagnostics
FDS/OPC Integration
6.
If the Diagnostic Gateway is located in a different subnet, enter its IP address in the Remote
subnet IP address field and choose Add.
Then choose Update to find all Diagnostic Gateways in the subnet.
Figure 5.15
7.
To identify a gateway in the cabinet, select the gateway from the list and choose Locate
selected gateway(s).
Gateways LEDs are flashing in the cabinet.
8.
Drag the Diagnostic Gateway from the Unassigned Diagnostic Gateways area on an
unassigned ??? port in the topology structure.
IP address and tag of the Diagnostic Gateway are automatically assigned to the port.
Figure 5.16
9.
Choose Apply to confirm changed settings.
5.4.5 Assign HD2-DM-A Addresses
Registering the Device Address of Diagnostic Modules
Each advanced diagnostic module (ADM) has a device address that is assigned directly on the
device. See chapter 4.1.2
In order to register the device address of each ADM, proceed as follows:
1.
Right-click the FieldConnex
Parameter.
2.
Select the FDS Topology tab.
3.
Select the ADM you want to configure in the topology structure.
4.
Select the device address for the selected ADM in the Address of the ADM drop-down list.
Figure 5.17
5.
Choose Apply to confirm changed settings.
60
Scanned gateways
Assigned gateway
® Diagnostic Server in the project section and choose
Device address settings