Knx Convertor For Vrf - Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual

2-20. KNX CONVERTOR FOR VRF

„ MODEL: UTY-VKGX „
„ SWITCH POSITION „
● Set KNX convertor rotary switch SET1 and dip switch SET2.
„
„ KNX CONVERTOR REMOTE CONTROLLER ADDRESS SETTING „
(SET 1)
z Example „
Refrigerant
circuit
SET1 (x10)
address
(10 digit)
01
15
Factory setting is "00"
*Setting range 00 - 15 (Arbitrary numbers can be set).
*When the Rotary switch is set to 16 or more, KNX convertor Remote Controller Address setting is 15.
* The sum total of the Touch panel controller, Central remote controller, Network convertor for Group remote controller,
Network convertor for L
*Address of the Touch panel controller, Central remote controller, Network convertor for Group remote controller,
Network convertor for L
*KNX convertor is connectable a maximum of 9 in 1 VRF network system.
SW setting
SET1 (x1)
(1 digit)
0 1
1 5
® ®
W , Modbus convertor and KNX convertor is a maximum of 16.
ON ORKS
® ®
W , Modbus convertor and KNX convertor must not be same.
ON ORKS
- (07-156) -