Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 806

„ SWITCHING SELECTION OF ADDRESS SETTING MODE „
4) To activate the address setting mode, hold down the three buttons of SET TEMP. V, SET
TEMP. Λ and FAN at the same time for 5 seconds or longer.
„ BUTTON NAME AND FUNCTION „
● Refer to "1-2" for an outline of the address setting.
● It does not matter whether the refrigerant circuit address or indoor unit address is set first.
(The method shown here sets the indoor unit address first.)
● During address setting mode, indoor unit reject the any operation command from remote controller.
Function number
01---Indoor unit address
02---Refrigerant circuit address
Remote controller address
Remote controller address
setting number 00-15
SET BACK button
Switches the remote controller
address setting number.
SET TIME "<" and ">" button
Switches the function number.
Address setting mode initial display
- (07-25) -
Setting number
Setting number
● Indoor unit address valid range 00-63
● Refrigerant circuit address valid range
00-99
Λ
SET TEMP. "V" and " " button
Switches the setting number.
TIMER SET button
Transmits address setting