Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 847

Hide thumbs Also See for AIRSTAGE J-III L AJ 072LELAH Series:

Table of Contents

„ FUNCTION SETTING

1) After verifying that the system is normally, press the MODE/EXIT button (SW107) once.

2) Press the SELECT button (SW108), and display "F2" on the LED104.

(Monitoring mode)

(The display of the LED104 changes each time when the SELECT button is pressed.)

*1: The "F1", "F8", and "F9" modes are used for maintenance, so do not set them in regular

3) When "F2" appears on the LED104, press the ENTER button (SW109).

A flashing display appears on the LED105, and the flashing display of "F2" on the LED104

changes to the illuminated display of a number.

4) Referring to the Settings List shown below, press the SELECT button (SW108) and display the

code number of the mode you want to set on the LED105.

Ex.) To select switching between Batch Stop and Emergency Stop

Next, press the ENTER button (SW109), and confirm the selection of the mode you want to

A flashing display on the LED105 changes to an illuminated display, and an illuminated display

on the LED104 changes to a flashing display.

(Setting mode)

(Function mode)

(Error history mode)

Show Quick Links

Table of Contents