Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 802

z Refrigerant circuit address setting „
Note : The refrigerant circuit address is displayed when the following operations are performed
even while indoor unit address is displayed on LED display of indoor unit.
(14) Press the "FAN" button to select the
function number.
Function number
(16) Press the "FAN" button to access the
address data setting mode. The address
data will flash once this button is pressed.
Address data
(18) Press the "START/STOP" button once to
send the information. A beeping noise will
be heard if the command is accepted.
¾ In the following cases the setting signal is not read
and a buzzer sounds.
The setting of the rotary switch on the PCB is not
"00" : Pi Pi Pi Pi Pi
z Confirmation of address setting
„
(20) Press the "TIMER set (+)" button.
"TIMER set (+)"
CORRECT : Pi
WRONG: Pi
Pi Pi
Pi PiPiPi
PiPi
PiPiPiPiPi
PiPi
(3 sec)
- (07-21) -
p
(15) Press the " " or the "
function number 02.
SET "02"
p
(17) Press the " " or the "
adjust the address data. The refrigerant
circuit address range is between 00 and 99.
Each time the "MODE" button is pressed, it
switches between the one's place and the
ten's place positions.
Range
00 - 99
: UP
: DOWN
(19) Indoor unit will display the refrigerant
circuit address data number on "TIMER
"(ORANGE) and "FILTER
OPERATION
(GREEN)
1 sec ON Flashing times of
address numbers
1 sec OFF
(the ten's place)
(Example) ADDRESS : 25
OPERATION LAMP
(GREEN)
0.5sec ON / 0.5sec OFF
TIMER LAMP
(ORANGE)
2 times
0.5sec ON / 0.5sec OFF
FILTER LAMP
(RED)
5 times
ADDRESS 0 setting will not indicate TIMER LAMP and
¾
FILTER LAMP.
ADDRESS display will automatically switched from
¾
indoor unit address to refrigerant circuit address.
q
" button to adjust
q
" buttons to
Change digit
"(RED) light.
TIMER FILTER
(ORANGE) (RED)
Flashing times of
address numbers
(the one's place)
1sec ON / 1sec OFF
1 - 10 sec
1 - 10 sec