Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 886

„ FUNCTION SETTING „
(6) Press the "MODE" button to access the
function setting mode.
(8) Press the "FAN" button to proceed to
setting the number. (Press the "FAN"
button again to return to the function
number selection.)
(10) Press the "START/STOP" button once to
send the information. A beeping sound will
be heard if the command is accepted.
¾ In the following cases the setting signal is not read
and a buzzer sounds.
The function setting No. is set out of range
: Pi Pi Pi Pi Pi
(7) Press the "
(9) Press the "
Case1 : When setting number is one digit.
(11-1) Indoor unit will display the function
Pi Pi
Pi PiPiPi
¾
- (07-105) -
p
" or the "
select the function number.
Each time the "MODE" button is pressed, it
switches between the one's place and the ten's
place positions.
p
" or the "
the setting number.
Each time the "MODE" button is pressed, it
switches between the one's place and the ten's
place positions.
setting number on "OPERATION"(GREEN),
"TIMER "(ORANGE) and "FILTER
"(RED) light.
OPERATION TIMER
(GREEN) (ORANGE)
Flashing times of Flashing times of
function numbers function numbers
(the ten's place) (the one's place)
(Example) Function number : 30, Setting number : 01
0.5sec ON / 0.5sec OFF
OPERATION LAMP
(GREEN)
3 times
TIMER LAMP
(ORANGE)
0.5sec ON / 0.5sec OFF
FILTER LAMP
1 time
(RED)
(Phase1) : 12sec
Number 0 setting will not indicate TIMER LAMP and
FILTER LAMP.
q
" buttons to
Change digit
q
" buttons to select
Change digit
FILTER
(RED)
Flashing times of
setting numbers
(the one's place)
...
3 times
OFF
...
1 time
(Phase1) : 12sec