Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 892

„ FUNCTION SETTING „
4) Pressing the SET BACK button, select a remote controller address (select the indoor unit
you want to operate)
5) Pressing the SET TIME < button or the SET TIME > button, to select the function number.
6) Pressing the SET TEMP. V button or the SET TEMP. Λ button, to select the setting number.
The display flashes during setting number selection.
7) Pressing the TIMER SET button, confirm the setting.
(The data will be transferred to the indoor unit.)
● When the data was not set up on the indoor
unit (-- is displayed.)
● Set up the data again according to the
procedure in step 5), 6) above.
„ FUNCTION DETAILS „
Refer to 2-9. FUNCTION DETAILS.
Remote controller address
Ex.) When remote controller address "01" is
selected
Function number
Setting number
Ex.) Function number : 30, Setting number : 01
ERROR
When the data was normally set up on the indoor
unit
(Flashing display changes to illuminated display.)
- (07-111) -
GOOD