Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 646

„ SWITCH AND CONNECTOR ETC. LOCATION ON PCB
„
AC power fuse
Battery for clock
PC connection port
(USB)
NOTE: Ensure proper space for all connectors when mounted.
CAUTION: Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used
Batteries according to the instructions.
IMPORTANT: Tight the Power Supply and the LON cables to one of the 4 cable tie holes fixed
to the casing with the plastic ties inside the BACnet
to tie one cable.
Power Supply
Connect mains to the power supply connector as:
1.- Brown: Line (L)
2.- Yellow: Earth / Ground (E)
3.- Blue: Neutral (N)
Ethernet / BACnet IP (UDP) / Console (UDP & TCP)
Connect the cable coming from the IP network to the connector ETH of the gateway. Use an
Ethernet CAT5 or higher cable.
VRF Network
Connect the LON bus to connectors A (+), B (-) and (SNGD) of gateway's PCB.
Console Port
Connect a mini-type B USB cable from your computer to the gateway to allow communication
between the Configuration Software and the gateway. Ethernet connection is also allowed for
configuration.
VRF Network
connection port
®
(BACnet )
Power LED
Error LED
®
Gateway (Hardware). Do not use 2 holes
- (05 - 178) -
BMS Network
connection port
(Ethernet)