Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 830

Hide thumbs Also See for AIRSTAGE J-III L AJ 072LELAH Series:

Table of Contents

„ COMPLETION OF ADDRESS SETTING MODE

14) To clear the address setting mode and return to the normal mode display, hold down the

three buttons of "MENU", "<" and "ENTER" at the same time for 2 seconds or longer.

„ SETTING UP EACH INDOOR UNIT

Repeat the procedures in steps 1) through 14), and set up the indoor units

requiring address setting.

„ RESET THE POWER AFTER SETTING UP ADDRESS OF ALL

INDOOR UNITS

¾ If the reset is not performed, address can not be read in normally.

¾ After all the addresses have been set, the circuit breaker needs to be switched off

for at least 2 minutes.

After the 2 minutes has passed, power can be restored.

¾ The set address is stored in the PCB and will remain in memory even when the

power is turned off.

However setting address is effective after power reset.

Record the address set in the indoor unit on a label, etc., and affix the label to the

unit so it can be used for after-sales service operations.

Normal mode display

Show Quick Links

Table of Contents