Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 820

Hide thumbs Also See for AIRSTAGE J-III L AJ 072LELAH Series:

Table of Contents

„ COMPLETION OF ADDRESS SETTING MODE

13) Press the three buttons of SET TEMP. p, SET TEMP. q and FAN at the same time for 5

seconds or longer. The address setting mode will be cleared and the normal mode display

will be restored.

¾ If no key entry is made for 60 seconds, even though none of the above buttons is

pressed, the address setting mode will automatically be cleared.

(If the address setting mode is automatically cleared while setting addresses,

activate the mode again according to the procedure in step 4) above.)

„ SETTING UP EACH INDOOR UNIT

Simple remote

Repeat the procedures in steps 1) through 13), and set up the indoor units

requiring address setting.

„ RESET THE POWER AFTER SETTING UP ADDRESS OF ALL

INDOOR UNITS

¾ If the reset is not performed, address can not be read in normally.

¾ After all the addresses have been set, the circuit breaker needs to be switched off

for at least 2 minutes.

After the 2 minutes has passed, power can be restored.

¾ The set address is stored in the PCB and will remain in memory even when the

power is turned off.

However setting address is effective after power reset.

Record the address set in the indoor unit on a label, etc., and affix the label to the

unit so it can be used for after-sales service operations.

Normal mode display

Simple remote

Show Quick Links

Table of Contents