Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 813

13) Setting results are displayed after data transmission.
● When indoor unit address data was not
set up on the indoor unit (-- is displayed.)
● Set up indoor unit address data again.
14) Press the " " button to return to the 2-wire remote controller address selection screen
of (2). If setting has been completed, press the FAN " " button to return to the Menu 2-F1
item selection screen.
Note:
● This item cannot be set from slave remote controllers.
z Refrigerant circuit address setting „
15) Select the 2-wire remote controller address with the SET TEMP. " " or SET TEMP. " "
button. Then press the "
16) Set the function number with the SET TEMP. " " or SET TEMP. " " button. Then press
the " " button.
Indoor unit address
ERROR
● When indoor unit address data was
normally set up on the indoor unit.
" button.
Select all
Function number
- (07-32) -
Ex.) When indoor unit
address data "12" is
set up
GOOD