Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 557

„ FUNCTIONS
„
3
6
Display panel
7
8
11
*1 : "AUTO " is not available for a heat pump model unless it is set up as an administrative indoor
unit.
*2 : "FAN " is not available for a heat pump model.
*3 : "HEAT " is not available for a cooling only model.
*4 : During address display mode.
*5 : For single split system, to use this function, set the Function setting of the indoor unit accordingly.
2
5
1
4
10
9
12
- (05 - 89) -
1 START/STOP button
Pressed to start and stop operation.
2 LED lamp
Lights during operation.
3 Set temperature button
Selects the setting temperature.
(18 to 30°C or 20 to 30°C [COOL], 10 to 30°C [HEAT])
* The lower limit of the setting temperature is different depending on
the place of use.
4 Fan control button
Selects the fan speed.
5 Louver button
Set the airflow direction.
6 Room temperature sensor(inside)
7 O p e r a t i n g m o d e i n d i c a t o r
FAN *2, HEAT *3)
8 Set temperature
Indicates Indoor unit address. *4
9 Fan speed indicator
(AUTO
10 Airflow direction indicator
11 Status icons
Mode mismatch
Filter sign *5
Defrost operation
Oil recovery operation
Under maintenance
Error
Special state
Conducting electricity
Emergency stop
Operation controlled
Forced stop
Remote controller sensor is enabled *5
Central controlled
Setting temperature range is enabled
Operation prohibited
12 Indicates the remote controller address. *4
( A U TO * 1 , C O O L , D RY
, HIGH , MED , LOW , QUIET
,
).