Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 938

„ VRF TERMINAL RESISTER SETTING (SET 2-1) „
When there is no outdoor unit or signal amplifier in the VRF network segment to which the converter is connected,
set to "ON."
ON: Terminal resistance enable
OFF: Terminal resistance invalid (Default)
„ TEST RUN SETTING (SET 2-3) „
Test run start and reset can be set.
ON: Test run starts
OFF: Test run resets (Default)
„ SCAN SETTING (SET 2-4) „
SCAN start and reset can be set.
ON: SCAN starts
OFF: SCAN resets (Default)
„ Programming Button (Prog Button) „
Used for communication with the ETS of tool for KNX.
ETS is a software, which runs on Windows
Push to toggle between the modes.
Runtime mode (Default)
[PROG LED off]
„ CONFIGURATION AND SETUP „
This is a fully compatible KNX device which must be configured and setup using standard KNX tool ETS.
For how to configure the settings from the ETS, refer to the Interface Specification.
ETS database for this device can be downloaded from:
http://fujitsu-general.com/global/support/downloads/vrf/index.html
®
platform based computers.
Programming mode
[PROG LED on]
- (07-157) -