Indoor Unit (Setting By Wireless Remote Controller) - Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual

2-3. INDOOR UNIT (setting by wireless remote controller)

● This procedure changes to the function settings used to control the indoor unit according to
„
the installation conditions. Incorrect settings can cause the indoor unit malfunction.
● After the power is turned on, perform the "FUNCTION SETTING" according to the
„
installation conditions using the remote controller.
● The settings may be selected between the following two: Function Number or Setting
„
Number.
● Settings will not be changed if invalid numbers or setting numbers are selected.
„
„ PREPARATION „
(1) Turn on the power to the indoor unit.
By turning on the power indoor units initializes EEV, so make sure the piping air-tight test and vacuuming
¾
have been conducted before turning on the power.
¾ Also check again to make sure no wiring mistakes were made before turning on the power.
Breaker ON
Indoor
units
- (07-102) -
Indoor
Indoor
units
unit