Table of Contents
Advertisement
„ INSTALLATION PROCEDURE
„
Before installation, connect between the VRF Network System and the USB Adaptor.
Brief installation steps are as follows:
(For detail, check the Instruction Manual.)
Step1: Install an appropriate driver for the USB Adaptor to the PC.
*In this step, do not connect the USB Adaptor to the PC.
Step2: Install the BACnet
Step3: Restart the PC.
Step4: After restarting the PC, make sure that the USB Adaptor, WHITE-USB-KEY, and
Ethernet cable for the BACnet
Step5: Start the application.
Step6: Configure necessary settings for startup operation as follows:
1. Perform all necessary initial settings such as IP address, etc. Then, click the OK
button.
Adaptor Setting window appears automatically.
2. Select the connected adaptor, and click OK button. Then, Unit Registration window
appears and starts scanning all connected units automatically.
3. After finishing the scanning, click OK button.
Gateway execution window appears on the display when the startup operation is
completed.
Step7: Arrange the information between BMS and BACnet
Service, etc.
®
Gateway (Application Software) to the PC.
®
Gateway are connected to the PC.
- (05 - 183) -
®
Gateway using the Read Property
Hide quick links:
Advertisement
Table of Contents
