Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 1121

„ PRECAUTION
„
● Select the installation location that meets the following requirement and that is approved by the
customer.
• Cold and warm air should reach the entire room.
D
D≦1000 mm
Floor
*1) Refer to Design & Technical manual for Air velocity distribution and Air temperature distribution during heating.
*2) If the distance from the ceiling is not adequate, it may cause mildew stains on the wall or the ceiling. (Ensure to fix
at least 150 mm away from any surface of the equipment.)
● Do not install the unit in the following areas
• The upper part of the vicinity of room entrance. It may cause condensation on the outlet port.
• Near a wall surface. It may cause condensation on the wall during cooling.
• Area filled with mineral oil or containing a large amount of splashed oil or steam, such as a kitchen.
• The place where it will be exposed to direct sunlight. Or else, it may cause a change in color.
● When the installation area is exposed to direct sunlight, take measures to block the light such as
covering the grille surface with a sheet. Or else, it may cause a change in color.
● Use an appropriate Grille that is compatible with the indoor unit. If not used with the correct
combination, it may cause condensation.
● Perform heat insulation and field setting according the Design & Technical manual of Indoor unit.
Not installing as per the instructions may cause condensation.
- (10 - 86) -