Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 818

„ ADDRESS SETTING „
z Indoor unit address setting „
5) Pressing the SET TEMP. p button or SET TEMP. q button, select a remote controller
address (select the indoor unit you want to operate).
6) Press the FAN button so that the "Function number" display flashes. Then, press either the
SET TEMP. p button or the SET TEMP. q button to display function number "01."
7) Press the FAN button so that the "Setting number" display flashes. Then, press either the
SET TEMP. p button or the SET TEMP. q button to set up the indoor unit address data. (The
setting range is from 00 to 63.)
8) Pressing the START/STOP button, confirm the selected indoor unit address data. (The
data will be transferred to the indoor unit.)
● When indoor unit address data was not set up
on the indoor unit (-- is displayed.)
● Set up indoor unit address data again
according to the procedure in step 7) above.
Remote controller address
Ex.) When remote controller address "01" is selected
Function number
Indoor unit address data
Ex.) When indoor unit address data "12" is set up
ERROR
When indoor unit address data was normally set
up on the indoor unit.
- (07-37) -
GOOD