Setting The Storage Location; Setting The Operator Names - Agilent Technologies WireScope 350 User Manual

2 On the Autotest Setup screen press Edit Settings. On the Autotest
1RWH
DsÃ’‚ˆÃ†h‰rƈ€€h…’Ãqh‡hy’Ã’‚ˆÃvyyÁ‚‡ÃirÃhiyrÇ‚Ã…rpr…‡vs’Ãyh‡r…Ðv‡uÇurÆh‰rqÃ
qh‡hÆvprÇurÃy‚‡†ÃvyyÁ‚‡ÃirÃh…‡Ã‚sÇurƇ‚…rqÃqh‡hȆrqÃs‚…Ã…rpr…‡vsvph‡v‚Ãi’Ã
Tp‚ƒr9h‡hÃQ…‚

Setting the Storage Location

This is the same function as that shown in the System Settings screen.
Also when a CompactFlash™ card is inserted, this function will
automatically set the storage location to the CompactFlash™ card See
Configuring CompactFlash™ Cards, on page 2-6.

Setting the Operator Names

The names of the technicians performing the tests can be entered, and
will appear on the test report. This is the same function as that shown in
the System Settings section See Entering the Operator Names, on
page 3-18. If it has been done already there, it is reflected here.
Settings screen press Save, then Edit to bring up the Save Mode
Setup screen. Press Summary Data Only or Full Data Set.
@‘ƒr…‡ÃH‚qrÃs‚…Ã8‚ƒƒr…ÃUr†‡vt
UurÃ@‘ƒr…‡Ã6ˆ‡‚‡r†‡ÃTr‡ˆƒ
6−17