11009 - Duplex Cam: Move Failed; 11010 - Duplex Cam: Software Command Failed On The Msc Bd; 11014 - Duplex Cam: Timeout Error; 11015 - Move Command Failed Because Slow Scan Not At Home Position - Kodak DirectView CR 825 Diagnostics Manual

DIAGNOSTICS
10DEC05

11009 - DUPLEX CAM: Move failed

DG4825-1
Page
67 of 180 Cause:
Action:

11010 - DUPLEX CAM: Software command failed on the MSC BD

Description: The DUPLEX CAM received a command to move that was not correct.
Cause 1: The DUPLEX CAM malfunctioned.
Action:
Cause 2: The MOTION SYSTEM CONTROL BOARD A1 malfunctioned.
Action:

11014 - DUPLEX CAM: Timeout Error

Description: The DUPLEX CAM did not move in the time allowed.
Cause:
Action:

11015 - Move command failed because SLOW SCAN not at Home Position

Cause 1: The DUPLEX CAM malfunctioned.
Action:
Cause 2: The SLOW SCAN CONTROLLER BOARD A6 malfunctioned.
Action:

11016 - MSC BOARD A1: Software Error for DUPLEX CAM

Description: The MOTION SYSTEM CONTROL BOARD A1 did not provide the RTXC
The DUPLEX CAM malfunctioned.
Do the checkout for the
Do the checkout for the
Do the checkout for the
The DUPLEX CAM malfunctioned.
Do the checkout for the
Do the checkout for the
Do the checkout for the
BOARD A7.
TIMER. This TIMER determines the timeouts for the motion of the
DUPLEX CAM.
CASSETTE HANDLING
CASSETTE HANDLING
MOTION SYSTEM CONTROL BOARD
CASSETTE HANDLING
CASSETTE HANDLING
SLOW SCAN CONTROLLER BOARD A6 and COIL
AY.
AY.
A1.
AY.
AY.
Error Codes