GE H
RAFT
EALTHCARE
D
KTD102576, R
IRECTION
3-6-2-2
Back End Processor Boot Up
When AC power is applied to the scanner, the ON/OFF Standby button on the control panel illuminates
NOTICE
amber, indicating that the System (including the Back-end Processor) is in Standby mode.
!! NOTICE:
5.) Hold down the ON/OFF Standby button (see:
NOTE:
The mains outlet of the system for peripheral auxiliary equipment are commonly switched with the
ON/OFF Standby button. The power switch of any attached printer(s) needs to be in ON position before
starting the system. However, be aware some auxiliary equipment may switch itself to standby mode
(e.g., Color video printer) and must therefore be switched on separately.
When the ON/OFF Standby button on the control panel is pressed, the System (including the Back-end
Processor) starts and the operating system is loaded which then leads the application software to
activate the scanner.
The system automatically performs an initialization sequence which includes the following:
-
-
-
As soon as the software has been loaded, the system enters 2D-Mode with the probe and application
that were used before the system was shut down.
NOTE:
Total time used for start-up is about 2 minutes.
6.) Adjust Height and position of control console.
Refer to
3-32
7
DRAFT (A
EVISION
Loading the operating system.
Running a quick diagnostic check of the system.
Detecting connected probes
Figure 3-26 ON/OFF Standby button on Control Panel
Section 6-5 "Control Console Positioning" on page
Section 3-6 - Completing the Set Up
23, 2012)
UGUST
Figure
3-26) on the control panel for ~3 seconds.
6-7.
V
E8 / V
OLUSON
OLUSON
S
M
ERVICE
ANUAL
ON/OFF Standby
button
E6