Connecting The Color Printer - GE Voluson E8 Service Manual

GE H DRAFT
EALTHCARE
D KTD102576, R
IRECTION
3-5-3

Connecting the Color Printer

1.) Power OFF/Shutdown the system as described in:
2.) Connect the Color printer according to connection scheme, see:
NOTE: The Color printer should be connected to the USB4 port of the Voluson E8 / Voluson E6´s PC-part.
Location of the USB4 port depends on the installed PC-Motherboard.
3.) When all the cables are connected, press the Power ON switch on the Color printer.
4.) Power ON/Boot up the Voluson E8 / Voluson E6 system as described in
31. All software drivers are pre-installed for the designated Color printer only.
Please
If the printer driver for the Sony UP-D25MD or Mitsubishi CP30D color printer is not pre-installed, install
Note
it manually by means of the "Found New Hardware Wizard" and the printer driver disk which is included
with this new printer.
5.) After physical connection to the Voluson E8 / Voluson E6 system, assign the printer to a remote key
(P1, P2, P3 and/or P4) as described in
6.) Verify the correct settings in the printer "Properties", see:
Settings" on page
After each installation, the leakage currents have to be measured according to
WARNING WARNING
IEC 60601-1 respectively UL 60601-1.
!! WARNING:
7 DRAFT (A
EVISION
3-41.
Chapter 3 - Setup Instructions
23, 2012)
UGUST
Section 3-6-3 on page
Section 3-7-5 "Remote Control Selection" on page
Section 3-7-4 "Adjustment of Printer
V E8 / V
OLUSON OLUSON
S
ERVICE
3-34.
Figure 3-7 on page 3-14
Section 3-6-2 on page 3-
E6
M
ANUAL
3-48.
3-13