GE Voluson E8 Service Manual page 304

GE H RAFT
EALTHCARE
D KTD102576, R
IRECTION
Section 7-9
Error Messages
NOTICE If the problem (error message) still exists after performing the described actions, call technical support.
!! NOTICE:
3D B_RxLines exceeded! Action: restart the system
3D B-O_Frames exceeded! Action: restart the system
3D C_RxLines exceeded! Action: restart the system
3D C-O_Frames exceeded! Action: restart the system
530-Probe connected on
530-Probe connected on left probe connector (A).
530-Probe connected on middle probe connector (B).
530-Probe connected on right probe connector (C).
530-Probe connected on upper-left probe connector (CW).
A USB-drive has been removed without stopping it. Unplugging or ejecting devices
without first stopping them can often cause crashes and lose valuable data.
AcquMode - incorrect BBC_Wnd pointer
Another drive is already assigned to "xx" that is no DVD/CD rec.
Cannot swap assignment.
Aperture Shape Form for 1.5D Array wasn't found !!! Action: restart the system
Application setting ApodTable field count mismatch
Application setting dynamic set field count mismatch
Application setting field count mismatch
Application setting RxFrqResponse field count mismatch
AVI Save function fails Action: check the connection and Power cable - restart the
machine and try again
B_Enhance Out Of Range
B_Gain Out Of Range
B_Reject Out Of Range
B_TxFocus - not calculated and B_SHOT_PART_ON
backward steps calculated in bGetUnitByStamp out of range
BBC_Acquisition Wnd - block creation failed
Action: restart the system
7-32
7 DRAFT (A
EVISION
Error Messages
Section 7-9 - Error Messages
23, 2012)
UGUST
restart the system
restart the system
restart the system
restart the system
Connect another Probe
Connect another Probe
Connect another Probe
Connect another Probe
Connect another Probe
press Ok, and stop it before removing it next time
restart the system
Use a DVD/CD writer
restart the system
restart the system
restart the system
restart the system
restart the system
see error message
press ok and save this user-setting once again
press ok and save this user-setting once again
press ok and save this user-setting once again
restart the system.
If after restart not ok then call technical support
restart the system
restart the system
V E8 / V
OLUSON OLUSON
S M
ERVICE ANUAL
Actions
E6