GE Voluson E8 Service Manual page 158

GE H RAFT
EALTHCARE
D KTD102576, R
IRECTION
4-4-6-3 3D/4D Sub Menu
Table 4-8
Step
1
2
3
4
5
6
7
8
9
For further details refer to the Voluson E8 / Voluson E6 Basic User Manual.
4-22
7 DRAFT (A
EVISION
Figure 4-18 3D/4D Sub Menu
Sub Menus
Task
PROBE ORIENTATION Adjust and activate the display of direction markers at border of the image.
GRAY/TINT MAPS Depending on individual requirements a "harder" or "softer" image can be obtained.
To select the desired Render View Direction.
RENDER VIEW
The green line symbolizes the direction of the view.
DIRECTION
Note: The Render View Direction keys are not available in Static 3D Sectional Planes.
3D/4D INFO On/Off switch to show full or reduced Image Info parameter on screen.
On/Off switch to show an acquired 3D+CFM, 3D+PD or 3D+HD-Flow image with or without
3D COLOR OFF
the color information.
GRAY 3D Adjusts the contrast and brightness of the rendered 3D image.
Adjusts the contrast of the screen background from dark to bright.
BACKGROUND
Note: This key is not available in Static 3D Sectional Planes mode.
Only available if a 3D+CFM, a 3D+PD or a 3D+HD-Flow image is acquired.
BALANCE
Note: Only available if a 3D+CFM, a 3D+PD or a 3D+HD-Flow image is acquired.
This function eliminates low color noise of motion artefact signals in the sectional slices as
POWER TRESH.
well as in the rendered 3D image.
Note: Only available if a 3D+CFM, a 3D+PD or a 3D+HD-Flow image is acquired.
Section 4-4 - Functional Checks
23, 2012)
UGUST
Expected Results
V E8 / V
OLUSON OLUSON
S M
ERVICE ANUAL
E6