GE Voluson E8 Service Manual page 325

GE H DRAFT
EALTHCARE
D KTD102576, R
IRECTION
8-2-5 System Software - Installation Procedure (FMI from DVD)
9.) Click the FMI FROM DVD button (see:
10.)Verify that only the DVD drive is connected to the system, then click OK
Figure 8-4 Verify that USB devices are disconnected, then click OK
11.)To start update procedure click YES
The system saves Full Backup in silent mode on R:, then it reboots into LINUX.
A silent "Rollback" image from C:\ is stored on R:\.
After executing all LINUX commands, the system reboots again.
NOTE: If the currently installed software has to be upgraded to a newer version, and the system DVD being
used is SW 9.0.3 or higher, a new software specific "Permanent key is required.
• Enter the appropriate "Permanent Key"
If the entered Permanent key is correct, following window appears, confirm with ENTER.
•
7 DRAFT (A
EVISION
Figure 8-5 Yes - start update procedure
Figure 8-6 insert Permanent Key
Figure 8-7 confirm Permanent Key
Chapter 8 - Replacement Procedures
23, 2012)
UGUST
Figure 8-3 on page 8-6) for updating the System Software.
(Figure 8-5 below).
select OK and confirm with ENTER.
(calculated in OKOS),
V E8 / V
OLUSON OLUSON
S M
ERVICE
(cont'd)
(Figure 8-4 below).
Note: This example shows
fictional numbers.
E6
ANUAL
8-7