Remote Control Selection; Report Printer Selection - GE Voluson E8 Service Manual

GE H RAFT
EALTHCARE
D KTD102576, R
IRECTION
3-7-5

Remote Control Selection

To assign an auxiliary device (e.g., printer) to the remote keys P1, P2, P3 and/or P4:
1.) Press the UTILITIES key on the control panel.
2.) In the "Utilities" menu touch SYSTEM SETUP to invoke the setup desktop on the screen.
3.) On the left side of the screen select CONNECTIVITY and then click the
Overview
Detailed Setup
Figure 3-50 System Setup - Connectivity - BUTTON CONFIGURATION page (Overview)
Overview tab:
•
-
-
-
NOTE: Optionally the Printer Remote Control can be done by the Foot switch.
(refer to:
Detailed Setup tab:
•
-
3-7-5-1

Report Printer Selection

1.) Click on the
(refer
2.) Select the desired Report Printer from the drop-down menu.
NOTICE
The selected Report Printer is usually used for printing reports and images from the Archive.
!! NOTICE:
3-48
7 DRAFT (A
EVISION
Configure "Remote" Buttons: Select the desired remote control button.
Select Printer: Check mark and select the desired Printer for the remote control button.
Recorder Control: Check mark this item to use the selected P? key for Recorder Control.
Figure 3-32: System Setup - Connectivity - PERIPHERALS page on page
If it is desired, check mark "Use Report Printer for Reports"
PERIPHERALS tab.
to:Figure 3-32: System Setup - Connectivity - PERIPHERALS page on page
Section 3-7 - Printer Installation
23, 2012)
UGUST
V E8 / V
OLUSON OLUSON
S M
ERVICE ANUAL
BUTTON CONFIGURATION tab.
Configure
buttons
Select
Printer
Recorder
Control
3-37)
3-37)
E6