GE Voluson E8 Service Manual page 139

GE H DRAFT
EALTHCARE
D KTD102576, R
IRECTION
4-3-1-1 Scanner Power On (cont'd)
5.) Hold down the ON/OFF Standby button (see:
NOTE: The mains outlet of the system for peripheral auxiliary equipment are commonly switched with the
ON/OFF Standby button. The power switch of any attached printer(s) needs to be in ON position before
starting the system. However, be aware some auxiliary equipment may switch itself to standby mode
(e.g., Color video printer) and must therefore be switched on separately.
As soon as the software has been loaded, the system enters 2D-Mode with the probe and application
that were used before the system was shut down. Total time used for start-up is about 2 minutes.
NOTE: The mains outlet of the system for peripheral auxiliary equipment are commonly switched with the
ON/OFF Standby button. So the auxiliary equipment need not to be switched ON/OFF separately.
7 DRAFT (A
EVISION
Figure 4-2 ON/OFF Standby button on Control Panel
Chapter 4 - Functional Checks
23, 2012)
UGUST
Figure 4-2) on the control panel for ~3 seconds.
V E8 / V
OLUSON OLUSON
S M
ERVICE ANUAL
ON/OFF Standby
button
4-3
E6