GE Voluson E8 Service Manual page 345

GE H DRAFT
EALTHCARE
D KTD102576, R
IRECTION
8-17-3-1 Installation Procedure at systems WITH power connector (cont'd)
4.) Connect the RGB Video Cable from the VGA Out Connector (on Voluson E8 / Voluson E6 system)
to the PC/HD IN Connector on the Image Resizer Box (see:
NOTICE Place the cable in a way, that it can not get damaged when moving the System or when the height of
the User Interface gets adjusted.
!! NOTICE:
5.) Connect the DC-Power Output from the Power Supply to the DC-Power Input at the Image Resizer
Box (see:
6.) Plug the Power Cable into the Power outlet above this shelf and plug the other end into the Power
Supply's input socket (see:
7.) Connect your Secondary Monitor to the Image Resizer Box at its PC/HD OUTPUT Connector.
8.) After the installation, Power ON/Boot up the system as described in
9.) Adjust the VGA Image Resizer settings as described in
10.)Measure leakage currents according to IEC 60601-1 respectively UL 60601-1.
7 DRAFT (A
EVISION
Figure 8-29 VGA Video Connection
Figure 8-29 above).
Figure 8-30
Figure 8-30 Power Connection
Figure 8-31 Connector for Secondary Monitor
Chapter 8 - Replacement Procedures
23, 2012)
UGUST
Figure 8-29
VGA Video Connection
below).
Connector for Secondary Monitor
Section 3-5-7-1 on page
V E8 / V
OLUSON OLUSON
S M
ERVICE ANUAL
below).
DC-Power
Input
Power Connection
Section 3-6-2 on page 3-31.
3-24.
E6
8-27