Connecting The Color Printer - GE Voluson P8 BT16 Basic Service Manual

GE RAFT
DIRECTION 5723243, R
3-5-3

Connecting the Color Printer

1.) Power OFF/Shutdown the system as described in:
2.) Connect the Color printer according to correct connection scheme as described in
page
NOTE: The Color printer should be connected to the USB1 port of the Voluson™ P8 / Voluson™ P6´s PC-part.
3.) When all the cables are connected, press the Power ON switch on the Color printer.
4.) Power ON/Boot up the Voluson™ P8 / Voluson™ P6 system as described in
3-25. All software drivers are pre-installed for the designated Color printer only.
5.) After physical connection to the Voluson™ P8 / Voluson™ P6 system, assign the printer to a remote
key (P1, P2, and P3 ) as described in
6.) Verify the correct settings in the printer "Properties", see:
Settings" on page
After each installation, the leakage currents have to be measured according to
WARNING WARNING
IEC 60601-1 respectively UL 60601-1.
!! WARNING:
3-16
6 DRAFT (M
EVISION
3-17.
3-48.
Section 3-5 - Connection of Auxiliary Devices
23, 2018)
AY
Section 3-6-3 on page
Section 3-7-8 "Remote Control Selection" on page
Section 3-7-7 "Adjustment of Printer
V ™ P8 / V
OLUSON OLUSON
B S M
ASIC ERVICE
3-29.
Figure 3-7 on
Section 3-6-2 on page
3-52.
™ P6
ANUAL