Tr32 And Rfi Boards Installation Procedure - GE Vivid i n Service Manual

GE H
EALTHCARE
D FL091021, R
IRECTION
8-3-2-5

TR32 and RFI Boards Installation Procedure

CAUTION: When installing boards, ESD may cause damage to a board. Always have the ESD hand
strip connected to the machine chassis and to your hand.
1) Re-connect the two TR32 Boards to each other (gently press together as shown in Figure 8-32 on
page 8-31 ).
2) Connect the TR32 Boards to the RFI Board (gently press together as shown in Figure 8-31 on page
8-30 ).
3) Return the TR32 and RFI Board assembly to the system, placing it in position on the Bottom
Assembly. (While performing this step, gently lift one side of the P&M Board upwards and hinge it
open in order to insert the TR32 and RFI Board assembly underneath). Refer to
Figure 8-30 on page 8-30 .
4.) Reconnect each of the two HVPS cables to the DC Power Supply (see Figure 8-28 on page 8-29 ).
5.) Reconnect the PCI cable flex (BEP-to-RFI) to the cable connector on RFI Board (see Figure 8-27
on page 8-28 ).
6.) Return the eight screws and fasten the TR32 and RFI Board assembly firmly in position on the
Bottom Assembly (refer to
7) Return the Control Panel and Keyboard to its original position, as described in the
and Keyboard Installation Procedure" on page
8.) Proceed to perform the following functionality tests:
-
-
-
8-32
5
EVISION
"Chassis Current Leakage Test" on page 10-25
"Calibration Tests" on page 7-15
"Full System Test" on page 7-9
Section 8-3 - Internal Component Replacement Procedures
Figure 8-25 and Figure 8-26 on page 8-28 ).
8-8.
V S M
IVID I N ERVICE ANUAL
Figure 8-29 and
"Control Panel