Table of Contents
Advertisement
GE H
EALTHCARE
D
FL091021, R
IRECTION
8-2-5-5
LCD Display Cover Installation Procedure
1.) Carefully place a replacement hinge in the correct position on the right side of the LCD Display
cover (refer to Figure 8-17 on page 8-18 ). Return and fasten the 2 screws (previously removed)
making sure the hinge is properly secured. Do not over-tighten the screws.
2.) Carefully place a replacement hinge in the correct position on the left side of the LCD Display cover
(refer to
is properly secured. Do not over-tighten the screws.
3.) Refit the LCD Display Frame, as described in the
page
4.) Return and fasten the 2 screws (previously removed) to each of the LCD hinges, making sure each
hinge is securely fastened to the Base Assembly - refer to Figure 8-16 on page 8-17 .
Do not over-tighten the screws.
5.) Reconnect the LCD flex cable to the BEP (refer to Figure 8-15 on page 8-16 ).
6.) Refit the Control Panel and Keyboard, as described in the
Procedure" on page
7.) Close and open the lid a few times to ensure proper closure of the LCD Display cover.
8) Reconnect the AC adapter and all cables to the Vivid i n.
9.) Proceed to perform the following functionality test:
-
5
EVISION
Figure
8-17). Return and fasten the 2 screws (previously removed) making sure the hinge
8-23.
8-8.
"Chassis Current Leakage Test" on page 10-25
Chapter 8 - Replacement Procedures
V
IVID I N
"LCD Display Frame Installation Procedure" on
"Control Panel and Keyboard Installation
S
M
ERVICE
ANUAL
8-19
Advertisement
Table of Contents
