GE Vivid i n Service Manual page 380

GE H
EALTHCARE
D FL091021, R
IRECTION
Table 8-2
Step
9 When prompted, type the following password:
geulsservice and press <Enter>.
Note: When typing the password, use lower-case letters.
10 Press <Eject> and remove the CD.
Press <CTRL+ALT+DELETE>.
11 Install software options as described in Chapter 3,
section 3-7-5 on page 3-61.
12 To verify the software version, press Config.
13 Verify that the software version 9.0.0 Build 52 with
System SW version 2.0.13 was correctly installed.
8-60
5
EVISION
Vivid i n Software Upgrade (BT06 to BT09) Procedure Vivid i n (cont'd) 2 of 3
Instruction
Section 8-4 - Software Loading
A message is displayed showing the current system ID.
The DVD then begins the software installation process and a progress indicator
is displayed, as shown below:
This stage of the process takes approximately 5 mins.
Note: Do not stop the software installation operation during this process!
At the end of the re-ghosting process, a message is displayed on-screen
prompting you to press <Eject> and remove the CD, then to press <CTRL + ALT
+ DELETE> to reboot the system.
The Ghosting process continues for approximately 10 minutes. The system
automatically loads the application and the system is ready for software option
installation.
The About screen opens, and from the System Version tab, the installed
software version is displayed on the screen
V S
IVID I N
Expected Result
M
ERVICE ANUAL