Front End Boards Installation Procedure - GE Vivid 4 BT03 RFI Service Manual

Table of Contents

2392751-100, R

4) Gently pull the required card from the crate.

CAUTION: When removing the card, ESD may cause damage to the card. Always have the ESD hand

strip connected to the machine chassis and to your hand.

Front End Boards Installation Procedure

1) Gently slide and push the required card to its original location, using the metal frame guiding tracks.

2) Use the plastic latches to firmly lock in the card in position, so that the connectors are firmly placed

in their sockets.

3) Return the front door of the crate to its original position and tighten the two screws that secure the

door in place.

4) Return the left side cover to its original position, as described in the

Note: When you insert a Front End Board into the crate, ensure that the probe connector's metal

frame slides into its tracks.

replaced. Refer to the instructions on page 6-13

on page 8 - 4.

Beamformer Calibration

Section 8-4 - Front End Parts Replacement

procedure must be performed each time a Beamformer is

Side Covers Installation