Table of Contents
Advertisement
GE H
EALTHCARE
D
FL091021, R
IRECTION
7-3-2-1
DC Offset Calibration (cont'd)
5.) Trackball to the Start button and press Set.
The DC Offset Calibration Test commences. While the test proceeds, the name of the test currently
in progress (DC Offset Calibration) is displayed in the Execute field and the current Loop # and
specific test are shown below. The messages Init Done and Please Wait are displayed beside the
progress bar in the Status area:
As the testing sequence progresses, the progress bar will advance to reflect the test progress.
Status indicators in the Data Flow map corresponding to the various system components will be
highlighted in the appropriate color to indicate the current test status, as follows:
•
•
•
6.) At any stage, trackball to the Pause button and press Set, if required.
7.) To resume testing (from the point where you paused), trackball to the Start button and press Set.
When the DC Offset Calibration Test sequence is complete:
-
-
Note:
There is one test report (ADC Offset values) which is listed in the Reports window on the
right. By default, this report is displayed in the Reports window below.
7-16
5
EVISION
Green: All recommended tests for these components have been completed and no problems
were identified.
Red:
Problems were identified in these components during the performance of the test.
Yellow: The tests executed so far on these components have passed, but not all
recommended tests have been performed.
the Diagnostic Test window displays the Finished message
the View Test Log window opens automatically, listing the test performed and showing
whether it passed or failed, as shown in the example in
Figure 7-7 View Test Log - DC Offset Calibration
Section 7-3 - Performing Full System Diagnostics
V
S
IVID I N
ERVICE
Figure
7-7.
M
ANUAL
Advertisement
Table of Contents
