Internet Protocol (Tcp/Ip) Properties - GE Vivid i n Service Manual

GE H
EALTHCARE
D FL091021, R
IRECTION
3-8-3-6 Configuring the Vivid i n and Network PC for Peer-to-Peer Connection (cont'd)
8.) Select Internet Protocol (TCP/IP).
9.) Click the Properties button.
The Internet Protocol (TCP/IP) Properties dialog box opens.
10.)Activate the Use the following IP address check box.
11.)Type in the Vivid i n IP address 10.0.0.1.
Note: The IP must be different from the IP address used for network computer.
12.)Type in the Subnet mask 255.255.255.0.
Note: The Subnet mask should be the same for both the network computer and the
Vivid i n.
13.)Click OK
14.)Press the Config button on the control panel to close all windows and return to the regular scanning
mode.
NOTE: The following steps are performed on the Network Computer.
1) On the network computer, access the Control Panel, as follows:
a.) Double-click on My Computer icon on desktop.
b.) Double-click on Control Panel icon.
2) Double-click on Network Connections icon.
3-74
5
EVISION
Figure 3-62 Internet Protocol (TCP/IP) Properties
Section 3-8 - Connectivity Setup
V S M
IVID I N ERVICE ANUAL