Lcd Display Installation Procedure - GE Vivid i n Service Manual

GE H
EALTHCARE
D FL091021, R
IRECTION
8-3-7-5

LCD Display Installation Procedure

1) Using both hands, carefully lift the replacement LCD Display into position on the Rear Cover &
Latch Assembly (refer to
Take care not to damage the LEC Flex ribbon cable when performing this step.
2.) Carefully re-connect the microphone to the LCD Flex.
3) Use both hands to re-connect the LCD Flex ribbon cable to the BEP - refer to Figure 8-44 on page
8-46 .
4) Return and fasten the four screws to secure the LCD Display to the Rear Cover & Latch Assembly
(refer to Figure 8-43 on page 8-45 ).
5) Return the LCD Display Frame, as described in the
page
6) Check that the LCD Display can be tilted upwards and downwards, and that it holds its set position.
7) Return the Control Panel and Keyboard as described in the
Installation Procedure" on page
8) Boot-up the system into Maintenance Mode.
5
EVISION
Figure
8-23.
Chapter 8 - Replacement Procedures
8-45).
"LCD Display Frame Installation Procedure" on
8-8.
V S
IVID I N ERVICE
"Control Panel and Keyboard
M
ANUAL
8-47