Setting The Bios - GE Vivid i n Service Manual

GE H
EALTHCARE
D FQ091013, R
IRECTION
8-5-2

Setting the BIOS

NOTE: This procedure is applicable to both MODBR949 and MODBR929 versions.
1) While booting, press F2 "Config / Diag" on alphanumeric keyboard
2) Type the password "marlin04".
3) Exit and save presets.
4) Select <Exit> section and load "Setup Defaults".
5) Select <Main> section.
6) Set correct System Time and System Date. Set Date using next format MM/DD/YYYY
7) Check that IDE Primary Master is detected.
8.) Proceed to
8-108
1
EVISION
Figure 8-108 BIOS Main Tab
Setting the BIOS Advanced Parameters on page 8 -
Section 8-5 - Software Loading
V V N S
IVID I N AND IVID Q
109.
M
ERVICE ANUAL