GE Vivid i n Service Manual page 583

Hide thumbs Also See for Vivid i n:

Table of Contents

LCD Display Installation Procedure

When performing the following installation procedure steps, it may be helpful to review the appropriate

movie clips previously referenced in the

1) Using both hands, carefully lift the replacement LCD Display into position on the Rear Cover &

Latch Assembly (refer to

Take care not to damage the LEC Flex ribbon cable when performing this step.

2) Use both hands to re-connect the LCD Flex ribbon cable to the BEP - refer to

3) Return and fasten the four screws to secure the LCD Display to the Rear Cover & Latch Assembly

4) Return the LCD Display Frame, as described in the

5) Check that the LCD Display can be tilted upwards and downwards, and that it holds its set position.

6) Return the Control Panel and Keyboard as described in the

Procedure on page 8 -

7) Return the bearing handle as described in the

8) Boot-up the system into Maintenance Mode.

Figure 8-62 on page

Chapter 8 - Replacement Procedures

LCD Display Removal

LCD Display Frame Installation Procedure on

Bearing Handle Installation Procedure on page 8 -

IVID I N AND

Figure 8-63 on

Control Panel and Keyboard Installation