Brightness Adjustment Procedure; Testing Your Contrast And Brightness Settings; Blue Tint Adjustment Procedure - GE Vivid i n Service Manual

GE H
EALTHCARE
D FQ091013, R
IRECTION
To assist in making Contrast adjustments, an adjustment bar is displayed below the screen:
Note: It is highly recommended to set the contrast to maximum. Press <ALT>+<Steer Right> to
increase the number of green bars to 7 (maximum).
6-2-2

Brightness Adjustment Procedure

To adjust the Brightness: hold down <ALT>:
•
-
-
To assist in making Brightness adjustments, an adjustment bar is displayed below the screen:
Note:
The screen Brightness is calibrated when the dark blocks on the left (numbers 1 through 6)
- see
6-2-3

Testing Your Contrast and Brightness Settings

Observe the
monitor is set to optimal settings when you just start seeing the
V Watermark
-
-
The Test Pattern in the Calibration Screen (refer to
Settings. (Press Alt + Q to access the Test Pattern).
6-2-4

Blue Tint Adjustment Procedure

This will make the white shades shift a bit towards bluish.
1
EVISION
Figure 6-2 LCD Display - Contrast Adjustment
Repeatedly press
Pg Dn
Repeatedly pressing
Pg Up
Figure 6-3 LCD Display - Brightness Adjustment
Figure 6-1 - and the white bars on the right (numbers 1 through 12) are all just visible.
V
watermark on the lower part of the monitor beside the soft keys on the screen. The
Figure 6-4 LCD Display - V Watermark Adjustment
V
If you do not see the
V
If the is clearly visible, the monitor has too much contrast or is set too bright.
Chapter 6 - Service Adjustments
to decrease the brightness
to increase the brightness.
, the monitor is set too dark.
Figure 6-1 on page
V V N S
IVID I N AND IVID Q
V
.
6-2) may be used for Advanced
M
ERVICE ANUAL
6-3