Adjusting The Safelock Cart Locking Mechanism - GE Vivid i n Service Manual

Hide thumbs Also See for Vivid i n:

Table of Contents

Adjusting the SafeLock Cart Locking Mechanism

The alignment procedure below is recommended in the event that when mounting the Vivid i n

and Vivid q N portable ultrasound scanner on the SafeLock Cart, the unit does not lock firmly

in position when inserted into the safelocks. Alternatively, if when removing the unit from the

Cart, it is difficult to disengage the safelocks.

1.) Working from the left side of the SafeLock Cart, remove the DVD from the DVD/CD-RW device.

Working from underneath the main shelf, loosen and remove the four screws (two each side) from

the DVD/CD-RW device bracket, then remove the bracket and the device - see

Note: only two screws

2.) Working from the underneath the main shelf, use a Phillips screwdriver to loosen the two screws

(half turn counter-clockwise) holding the middle locking tooth in position on both the left and right

sides of the main shelf, as shown below.

Middle Locking Teeth Viewed from Top of Shelf

Figure 3-67 Figure 3-86--Adjusting the SafeLock Cart Locking Mechanism

3.) Check that the Vivid i n and Vivid q N portable ultrasound scanner is locked correctly onto the two

rear locking teeth (if not, push the scanner fully back into position until an audible click is heard).

4.) Carefully tighten the four screws previously loosened in

5.) Reconfirm that the scanner is firmly locked into position and there is no excess play (movement)

between the scanner and the Cart before returning the DVD/CD-RW device and bracket.

Section 3-8 - Mounting the Vivid i n/ Vivid q N on the SafeLock Cart (optional)

visible in picture

Figure 3-66 Figure 3-85--DVD/CD Device and Bracket

IVID I N AND

Screws Viewed from Beneath Shelf

Figure 3-67 on