GE Vivid i n Service Manual page 113

GE H
EALTHCARE
D FQ091013, R
IRECTION
3-7-2-6 USB Memory Stick
IMPORTANT During Stand-by mode, it is NOT recommended to introduce or remove USB
NOTICE
devices; this may cause the system to lock-up during the boot-up procedure.
The USB Memory Stick (disk-on-key) connection in the different scenarios is explained below.
No SafeLock Cart - connection directly to the Vivid i n/ Vivid q N system
•
The USB Memory Stick may be connected to either of the USB ports (upper or lower) on the rear
connectors panel.
The USB Memory Stick can be connected once the system is powered ON, or after shutdown. All
software drivers for the USB Memory Stick are pre-installed on the system. The system is capable
of detecting and working with other types of memory sticks. However, it is highly recommended to
use the memory stick that is provided and approved by GE Medical Systems. Other memory sticks
may be sensitive to EMC interference - this may affect system performance and/or image quality.
• No SafeLock Cart - connection via USB hub
As above. If applicable, the USB hub must be powered via the isolation transformer.
• Vivid i n/ Vivid q N mounted on SafeLock Cart
As above.
3-7-2-7 Footswitch
IMPORTANT During Stand-by mode, it is NOT recommended to introduce or remove USB
NOTICE
devices; this may cause the system to lock-up during the boot-up procedure.
The Footswitch (USB) connection in the different scenarios is explained below.
No SafeLock Cart - connection directly to the Vivid i n/ Vivid q N system
•
The Footswitch may be connected to either of the USB ports (upper or lower) on the rear connectors
panel.
The Footswitch can be connected once the system is powered ON, or after shutdown. All software
drivers for the Footswitch are pre-installed on the system.
• No SafeLock Cart - connection via USB hub
As above. If applicable, the USB hub must be powered via the isolation transformer.
1
EVISION
Figure 3-40 Footswitch
Chapter 3 - System Setup
V V N S
IVID I N AND IVID Q
M
ERVICE ANUAL
3-45