Huawei NetEngine40E Hardware Description page 77

HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Interface Name
CTL-ETH-SFP
interface
(1000MBase-X)
MGMT-ETH interface
(10M/100M/1000M
Base-TX auto-sensing)
Console interface
AUX interface
CLK/TOD0
CLK/TOD1
CLK/1PPS
CLK/Serial
Interface Attributes
Table 3-13
Table 3-13 1000MBase-X-SFP interface attributes
Attribute
Connector type
Operation mode
Standard
compliance
Cable
specification
Table 3-14
Issue 01 (2012-09-30)
Bits2 includes 2 SMB ports, and the signal type can be set as 2Mbps/2Mhz/1PPS+RS232. When signal
is 2Mbps/2Mhz, CLK/1PPS is fixed as input and CLK/Serial is fixed as output. When signal is
1PPS+RS232, CLK/1PPS and CLK/Serial are bound together, CLK/1PPS signal type is 1PPS whereas
CLK/Serial signal type is RS232, and the setting of input/output apply to both SMB ports.
lists the 1000MBase-X-SFP interface attributes.
Description
SFP
1000 M fiber
IEEE 802.3-2002
Single-mode or multi-mode fibers
lists the 10Base-T/100Base-TX/1000Base-T-RJ45 interface attributes.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Connector
Description
Type
SFP It is not used and reserved for future capacity
expansion.
RJ45 It connects to the NMS workstation and has
LINK and ACT indicators.
RJ45 It connects to the console for on-site
configuration of the system.
RJ45 It connects to the Modem for remote
maintenance through dialing.
RJ45 It is used to input or output 2-Mbit/s clock
signals, 2-MHz clock signals, 1pps+ASCII
clock signals, or 2-channel DCLS clock
signals.
SMB It is used to input or output 2-Mbit/s clock
signals, 2-MHz clock signals, or 1 PPS signals.
SMB It is used to input or output 2-Mbit/s clock
signals, 2-MHz clock signals, or RS232
signals.
3 NE40E-X8 Chassis Overview
63